Nowadays, in the LED industry, the LED dispenser also has a very large area, covering many consumer areas, such as electronic lighting industry, mechanical hardware industry, automobile manufacturing industry, etc. the characteristics of LED dispenser are.
The inspection skills of dispensing quality of high-speed dispenser: beating, liquid crystal detection, identification, pressurization, acoustic resistance and ultrasonic method. For sealed pressure bonding parts, pressure sealing inspection can be carrie.
1. If the dispensing needle is reused, multiple mixing interference will occur. The manufacturer of UV glue will be very strict and control the quality of UV glue from beginning to end. When the external dispensing needle or fluid pipeline is connected, a.
The amount of glue dispensed depends on the following key points: glue viscosity, load, glue supply time and instant break, so many factors need to be considered in order to complete high viscosity glue dispensing. High viscosity filler According to the a.
Heat to remove the gelled glue on the dispensing needle, because the gelled glue and led conductive silver glue have a very fast solidification efficiency. Once the dispensing needle of the high-speed dispensing machine with gelled glue is not well select.
In many areas, the dispensing process is also called gluing or even dropping. That is to apply electronic glue, oil or even other liquids to the products, so that the products can have the effects of sticking, potting, insulation, stability, surface smoot.
The application of the automatic dispensing machine involves all aspects. It is applicable to the spot application of glue and also supports the control application of paint materials. This time, the difference between paint and paint will be explained, w.
There are many glue filling methods. Usually, there are two-component glue filling methods (two-component epoxy resin, two-component polyurethane, two-component silicone rubber and other two-liquid resin materials) Floor type automatic glue filling equipm.
Electronic equipment has always been the most critical output standard of automatic dispenser manufacturers. The manufacturers of automatic dispenser and automatic dispenser are willing to compete for the electronic equipment industry. The most important .
How to choose to use my factorys intelligent automatic dispensing machine? Filling silicone dispenser When purchasing such products, we can follow a lot of factors. Its basically how to carry out the dispensing machine for the factory. At present, such pr.
Most of the guests choose the dispenser for spot coating due to the difference in process. They may need to change the glue when spot coating the products of the specified category, but the glue of the different categories will have chemical reaction when.
In the process of using hot melt glue machine, some problems are more or less encountered in the process of using. For example, if the hot melt glue machine does not produce glue, another problem is very common. Do you know how this is caused? How to solv.
How to distinguish dispensing machine and filling machine: In short, dispensing machine can also be called glue filling machine. There are some differences in the terms of different areas. Some areas are also called glue loading machine, gluing machine is.
The change of climate has a little change of working temperature and environmental humidity. In the rainy season, the relative humidity of air is relatively high. Once the problem of climate affecting glue is not considered, it is likely to cause incomple.
Accessories are the components of dispensing machine that can cause operation, and most of the users have certain knowledge restrictions on the purchase of dispensing accessories. This small edition of medium-sized system leads you to take the relevant kn.
The principle of visual dispensing machine is simpler than that of manual packaging equipment. It is to push the glue into the rubber bottle (injection needle) according to the compressed air, and press the glue into the feed pipe connected with the pisto.
This specific description is the dispensing machine cleaning process and related points for attention 331 platform automatic dispensing machine I. cleaning of automatic dispensing machine for replacing glue 1. Check what kind of cleaning solution should b.
In the semiconductor industry, the effect of automatic dispensing equipment is becoming more and more prominent. Whether in manufacturing or in operation, automatic dispensing equipment has brought many conveniences to users and operators. This discussion.